Spent time resolving the joinery for Chair 2.0 in SketchUp today.
One of the advantages of the Domino is less marking out for joinery if you can use the built in stops and board thickness slide to locate the mortices. By juggling with the presets and manually adjusted jointing heights you can set rails in from the outer faces of the legs.
Legs are square on rather than in the same plane as the side rails so the compound angle cuts are all in the side rails. Mortices shouldn't be much trouble with the Domino but cutting to length will need both the saw blade tilted and the rail ends cut at an angle. I've resolved the angles and designed jigs and hope to get the side rails cut to length tomorrow.
Seat material hasn't arrived yet so I'm leaving room to adjust the rails to have the outer face of the legs flush with the seat edges. Once I know the diameter of the cord I'll be able to cut the mortices and do a dry fit.
0 Comments:
Post a Comment